40422 Media Handler MDH: Preloader requested for loading, but the Trendsetter is not configured properly The bay is configured to use the preloader to load plates into the bay, but the Preloader option is not enabled. This could happen if the "bay UsePreloader" parameter is set without the option being configured. The preloader option can be checked using the "option" command. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. Preloader option is not enabled 14-Aug-2002 ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:26 2008 PST